|
|
COMPTROL+
Bender Controller
The COMPTROL computer bender controller was designed from the board
level up as a dedicated bender controller. The design was based entirely
upon the needs of the tube bender. With the optional CNC Module,
the COMPTROL is capable of 3-axis CNC operation.
With a bright 4 x 20 Vacuum Fluorescent Display and intuitive displays
and menus in plain English, the COMPTROL is easy to use.
The COMPTROL features a programmable safety switch to enable two handed
operation with anti-holddown, anti-repeat logics for OSHA compliance.
To aid in two handed operation, the COMPTROL has built in support for
air clamping to hold the parts in place when both hands are on the
control.
|
Features
• Programmable
bend angles to 0.1 degree for improved bend accuracy.
• Extensive part storage.
• Automatic part counter.
• Alphanumeric part names.
• Intuitive menu driven part and setup screens.
• Bright, easy to read Vacuum Fluorescent Display.
• Integrated manual and automatic modes.
• Bend arm deceleration for two speed benders.
• Programmable boost delay.
• Early mandrel extraction.
• Three return modes (manual, semi-automatic, and automatic).
• Programmable mandrel oscillation.
• Two mandrel sequence modes for ease of loading parts (normal and inhibit
advance).
• Programmable lube angles.
• Real-time displays of bend arm angle and part data.
• Quadrature encoder with 0.1 degree resolution.
• All mounting brackets, schematics, and installation instructions included.
• Quick disconnect connector for easy installation.
• Programmable safety switch for two handed bended.
• Detailed status line for automatic mode.
• Integral air clamp support for “Two Hands on Control” operation.
• 3-axis control with optional CNC Module.
• Supports benders with sequence or hydraulic dump valves.
• Optional remote pedestal and stand available.
• Lifetime warranty on COMPTROL board.
• Free support and software upgrades.
|
Sierra Controllers
11657 Winding Ridge Drive
San Diego, CA 92131
(858) 204-0454
www.sierra-corp.com
|
