Pines #4 Hydraulic Tube Bender

Used Pines #4 Hydraulic Tube Bender

Overhead Tie Bar

LH (Counterclockwise) Rotation

Hydraulic Mandrel Extractor

In-Line Pressure Die Assist

Wiper Die Holder Assembly

NEW Sierra Digital Control – (2) Year Board Warranty

Capacities:
Round tubing, mild steel Y.P. to 40,000 psi – 6” x .165
Round Tubing, non-ferrous Y.P. to 25,000 psi – 6” x .250
Round tubing, Stainless steel Y.P. to 60,000 psi – 6” x .095
Steel pipe, schedule 80 – 4” NPS
Square tubing, mild steel – 4” x .235
Specifications
Maximum standard radius – 24” (Approx 18″ because of the In-Line Pressure Die Assist)
Minimum radius to diameter ratio – 1
Maximum bend angle – 190º
Bend arm repeatability – +/- .1º
Maximum standard tube length over mandrel – 162”
Bend arm speed – 3.5 RPM avg. (180°)
Motor horsepower – 20HP
Approximate weight – 12,600 lbs.

Current work so far on the bender:

• Slides For Clamp & Pressure Die Clamp
  • Dust cut & install new phenolic wear strips
  • New Brass Slide Guards
• New Wear Bottom Wear Strips
• New Phenolic Wear Strips
• New 1-1/2″ Pins
• Pressure Die Assist Unit
  • New Bearings
    • (2) CYR4-S
    • (2) CF1-1/2-SB
    • (4) CF1-3/4-SB
  • New Pins
• New Hydraulic Hoses
  • (2) Clamp Cylinder
  • (2) Pressure Die Clamp Cylinder
  • (2) PDA
  • (2) Mandrel
• New Back Up Blocks (2) Each
  • 2″, 3″, 4″ 5″, 6″
• New Bend Die Key
• New gaskets on side covers